M600 (A3 + LIGHBRIDGE 2)

• 01. Does Pixy U support M600 or A3 + Lighbridge 2 control?
  Pixy U supports control through M600 or any drone frame using A3 FC and Lightbridge 2.
• 02. Which kind of operator does Pixy U support?
  Pixy U supports both of single and dual operator (slave and master ).
• 03. How to configure Gremsy gimbal to use with DJI Lightbridge 2 or M600’s remote?
  • Step 1: Install the lasted Software/Firmware

  The firmware and software were updated at Download.
  

  • Step 2: Connect Gremsy gimbal to GPS of Flight controller A3/N3
    

  • Step 3: Select Single or Dual Mode

  At Single Mode, in software:

   - Go to Setting -> Controls -> LightBridge 2 -> Single
  - Move GIMBAL DIAL on the remote to turn on the motors.
  - Toggle C1 to control tilt or pan (make sure Tilt in TILT LOCK , go to SETTINGS -> FOLLOW-TILT->TILT LOCK).
  - Pan will be in follow mode if not use GIMBAL DIAL for PAN control.
  
  
  
  At Dual Mode, in software:

  - Go to Setting -> Controls -> LightBridge 2 -> Dual
  
  - Move GIMBAL DIAL on the remote to turn on the motors.
  
  - Use Tilt/roll/pan stick to control tilt/roll/pan.