LightBridge 2

• 01. I want to enhance/decrease tilt and pan speed.

  Simple way: Change smooth value, input range [0,255]

  

• 02. How to set HOME position for YAW axis?
  The HOME position of YAW axis is not fixed. This position will be applied when the first power ON and then motor ON (Motor ON is active by Wheel on Lightbride 2).
  If you need the YAW axis follow with forward direct of aircraft , make sure the YAW axis is mate with forward direct of aircraft before the first power ON.
• 03. Can I control Gremsy gimbal via Light Bridge 2?
  Yes, you can. At present, Gremsy T1/T3 supports to use in single control via LightBridge 2, applied for A3/N3 Flight controller only.
• 04. How to configure Gremsy gimbal to use with DJI Lightbridge 2 or M600’s remote ?

  Step 1: Install the lasted Software/Firmware
  
  The firmware and software were updated at Download.
  
  Step 2: Connect Gremsy gimbal to GPS of Flight controller A3/N3

  Watch this video: Gremsy T3: How to control on DJI M600!

  Step 3: Select Single or Dual Mode
  
  At Single Mode, in software: Go to Setting -> Controls -> LightBridge 2 -> Single
  

  • Move GIMBAL DIAL on the remote to turn on the motors.
    
  • Toggle C1 to control tilt or pan (make sure Tilt in TILT LOCK , go to SETTINGS -> FOLLOW-TILT->TILT LOCK).
  •  Pan will be in follow mode if not use GIMBAL DIAL for PAN control.

  

  At Dual Mode, in software: Go to Setting -> Controls -> LightBridge 2 -> Dual
  

  • Move GIMBAL DIAL on the remote to turn on the motors.
  • Use Tilt/roll/pan stick to control tilt/roll/pan.

  

  Learn more tutorial at  How to install LightBridge 2 to the T1/T3 gimbal.